
Product Introduction – VOLVO A40F High‑Pressure Travel Pump 15140666 / VOE15140666
This high‑pressure, variable‑displacement axial‑piston pump (part numbers 15140666 / VOE15140666) is a Genuine VOLVO travel drive pump widely used on Volvo A40F articulated dump trucks. It features a swashplate design for open‑circuit hydrostatic transmission, delivering stepless flow/pressure control, fast response, and high efficiency for demanding haul cycles. The ALA10VO series offers multiple control options and through‑drive capability for auxiliary pumps.
Key Specifications and Features
Type: Axial‑piston, variable displacement, open circuithydrostatic pump with swashplate actuation.
Model family: ALA10VO; common displacement for A40F applications is 60 cm³/rev (verify exact displacement with S/N).
Rated pressure: 280 bar (nominal).
Control options: DG (two-point direct control), DR (pressure control), DRG (remote pressure), DFR/DFR1 (pressure & flow), DFLR (pressure/flow/power), ED/ER (electro-hydraulic).
Through‑drive: Integrated SAE through‑shaft for mounting a gear pump or a second axial piston pump of equal or smaller size.
Design highlights: High power density, low noise, compact build; suitable for heavy-duty, high-cycle applications.
Typical Applications
Primary travel drive on Volvo A40F articulated dump trucks in mining, quarry, and heavy construction.
Any open‑circuit, high‑pressure application requiring load‑sensing/flow‑on‑demand control and compact installation.
Ordering and Cross‑Reference Guidance
Provide: machine model and serial number (S/N), required displacement (e.g., 60 cm³/rev), control type (e.g., DFR1/DFLR), rotation direction, mounting flange and port standard (SAE/ISO), shaft type/keyway, seal material (NBR/FKM), and hydraulic fluidspecification.
Confirm the exact build (control code, through‑drive, shaft, ports) in Volvo PROSIS or the official parts catalog using the S/N before ordering.
This part is also listed in aftermarket catalogs for A40Fwith cross reference VOE15140666.
Installation and Commissioning Essentials
Perform a full hydraulic flush; pre‑fill the pump to remove air. Ensure adequate suctionand that the case drain returns to tank with minimal backpressure.
Observe tightening torques and porting per data sheet; avoid restrictive fittings or check valves on the case drain line.
After start-up, check for leaks, abnormal noise/vibration, and verify response to control inputs and system pressure.
Maintain clean hydraulic fluid and filters; follow recommended service intervals for seals and bearings.












