
Product Introduction – VOLVO 160 Fan Pump 14562999 / VOE14562999
Clarification & Application Context
In Volvo construction equipment, engine cooling fan drives are usually powered by variable-displacement axial piston pumps (with pressure compensation or electro‑proportional control) to achieve stepless speed regulation based on thermal load. Gear pumps are generally fixed-displacement units used for low-pressure auxiliary circuits (e.g., pilot control, brake release), and are not commonly employed as variable fan drive pumps. Therefore, a “fan pump” described as a gear pump is uncommon and should be verified against nameplate and circuit diagrams to avoid incorrect replacement.
Compatibility & Alternative Reference
If your machine requires a variable fan drive pump, refer to the platform’s standard part VOE14530502, which fits models such as EC330B/C, EC360B/C, EC460B/C, EC340D, EC380D, EC480D, ECR145C, PL4809D, etc. This unit enables fan speed control according to engine heat load, improving efficiency and reducing noise.
If your documentation or nameplate clearly lists 14562999 / VOE14562999, treat it as a gear pump (likely for pilot or auxiliary circuit, not fan drive). To ensure correct fitment:
Provide machine model and serial number (S/N).
Identify installation side (LH/RH) and circuit function.
Use Volvo PROSIS or official parts catalog to confirm location, displacement, rotation direction, mounting flange, port standard (SAE/ISO), and shaft type.
Ordering & Pre‑Delivery Checklist
Equipment info: Brand & model, serial number, installation side, circuit name.
Pump type confirmation: Variable piston vs. gear pump (check nameplate/circuit diagram/photo).
Key specs: Displacement (cc/rev), max working pressure, control method (pressure compensated / load sensing / electro‑proportional), rotation direction (viewed from shaft end), mounting flange & port standard (SAE/ISO).
Media & seals: Hydraulic oil spec, seal material (NBR / FKM), operating temperature range.
Physical comparison: Nameplate, dimensions, shaft / spline spec, port thread & dowel pin locations.
Supply channel & warranty: Choose Genuine VOLVO (VOE) or reputable remanufactured/compatible supplier; request test reports (flow/pressure curves, leak & noise tests) and warranty terms.
Installation & Commissioning Tips
System flushing: Clean circuit thoroughly before fitting; ensure sufficient suction flow, direct case drain to tank with minimal backpressure.
Priming: Manually or briefly run prime procedure to remove air; avoid dry running.
Control & interlock: Set compensating differential pressure or electro-proportional signal per control scheme; verify correct logic with temperature sensor / ECU so fan speed varies smoothly with load/temperature.
Operation checks: Monitor noise, vibration, temperature rise, leakage, and pressure fluctuation; confirm actual speed/flow meets cooling requirement.
Maintenance: Follow scheduled oil & filter changes, inspect shaft seal & bearing wear, keep installation & setup records for traceability.
This overview helps ensure you select and install the correct pump for your Volvo machine’s cooling or auxiliary circuit, maximizing reliability and performance.












