
Product Introduction – CAT Fan Pump 155‑9222 / 1559222 for 365 / 385C / 374 / 390D Excavators
This piston-type hydraulic pump is the dedicated fan drive pump for Caterpillar excavators including 365, 385C, 374, and 390D models. Identified by part number 155‑9222 / 1559222, it supplies high‑pressure flow to the engine cooling fan circuit, enabling temperature‑controlled, variable‑speed fan operation for efficient thermal management and reduced noise. The pump is commonly described in parts catalogs with a 13/15 teeth gear specification on the drive coupling, indicating the tooth count on the pump drive gear for timing/alignment with the engine’s drive system.
Key Features & Benefits
Axial‑piston, fixed or variable displacement design (configuration dependent on build) tailored for fan drive circuits.
Provides steady high‑pressure flow to maintain fan speed in proportion to engine coolant or hydraulic oil temperature.
13/15 teeth gear on drive coupling ensures correct engagement with engine drive for proper timing and smooth power transfer.
Compact, durable construction for continuous operation in high‑ambient and high‑load environments.
Reduces cooling‑related downtime and improves fuel efficiency by avoiding constant high fan speed.
Typical Applications
Cooling fan drive on CAT 365, 385C, 374, 390D excavators.
Replaces worn or failed fan pumps to restore proper engine temperature control.
Used in both standard and high‑ambient temperature operation where engine cooling demand varies significantly.
Ordering & Cross‑Reference Guidance
Provide machine model and serial number (S/N) to confirm exact pump configuration (displacement, control type, shaft, ports, rotation, seal material).
Verify 13/15 teeth gear detail matches the existing drive gear on your machine to ensure proper fit and alignment.
Specify new (155‑9222) or quality‑assured remanufactured/compatible unit; confirm warranty and core return policy if applicable.
Always check CAT Parts Catalog / PROSIS using the S/N before purchase, as fan pump configurations may vary by production period and regional build.
Installation & Maintenance Essentials
Perform a full hydraulic flush before installation; pre‑fill pump to remove air. Ensure adequate suction and that case drain returns to tank with minimal backpressure.
Align drive gear timing carefully (13/15 teeth match) to prevent premature wear or noise.
Observe tightening torques and porting per data sheet; avoid restrictive fittings or check valves on the case drain line.
After start-up, check for leaks, abnormal noise/vibration, and verify fan speed responds correctly to engine temperature.
Maintain clean hydraulic fluid and filters; follow recommended service intervals for seals and bearings.
This fan pump ensures reliable engine cooling performance for large CAT excavators, helping protect vital components and maintain productivity in the toughest working conditions.












