
Caterpillar 305.5 306E 307 308 Main Pump 455‑7974 Fitment
Pump type and machine family
The 305.5/306E/307/308 family uses a variable-displacement axial-piston main pump in a load‑sensing hydraulic system. Example specification for the 305.5E2: pump flow about 140 L/min at 2,400 rpm, with system pressures around 24.5 MPa (equipment/travel) and 21.6 MPa (swing). These parameters define the performance class the main pump must meet.
The 455-7974 main pump is a genuine Caterpillar part number used on multiple Caterpillar mini-excavator models in the 305.5–308 size class. It is supplied as the complete main hydraulic pump assembly for these machines. Always match by model + serial number because build variants and attachments can change the exact P/N.
How to confirm this pump for your serial
Read the pump nameplate (the P/N on the pump body is the final authority).
Provide your machine’s model and exact serial number to a CAT dealer or reliable parts supplier and request an SIS parts lookup to verify 455-7974 against your configuration.
Check the pump’s flange pattern, shaft keyway, port locations, and flow/pressure rating during fitment to ensure they match the machine’s hydraulic circuit and mounts.
Sourcing and ordering notes
The 305.5/306E/307/308 family is widely supported by aftermarket suppliers offering OEM and reman main pump options; availability and lead time vary by region and stock.
If your verification confirms 455‑7974, order the P/N exactly as on the pump nameplate; if the tag differs, use the nameplate P/N.
Plan for ancillary work during replacement: inspect and, if needed, replace suction strainer/filter, check case drain, verify relief and control settings, and bleed the system to remove air. Use only hydraulic oil that meets Cat HYDO Advanced or equivalent OEM specification.
Avoiding common mix‑ups
Do not confuse the main hydraulic pump with the engine cooling fan pump (fan pumps are smaller assemblies dedicated to the cooling circuit).
Do not assume interchangeability across different machine sub‑configurations (e.g., blade, long/short stick, different control systems) without SIS/nameplate verification.












