English
The following table is gear pump in the use of some common fault phenomena and troubleshooting
创建于05.17
Troubleshooting
The following table is gear pump in the use of some common fault phenomena and troubleshooting.
Gear pump in the use of some common fault phenomena and troubleshooting
Fault phenomenon | Cause analysis | Exclusion method |
1. There is no oil or pressure in the pump | (1) The rotation direction of prime mover and pump is inconsistent | (1) Correct the rotation direction of prime mover |
(2) Pump drive key off | (2) Re install the drive key |
|
(3) The oil inlet and outlet are connected reversely | (3) Select the correct connection method according to the instruction manual |
|
(4) The oil level in the oil tank is too low, and the liquid level of the suction pipe is exposed | (4) Replenish the oil above the minimum level line |
|
(5) Too low speed and insufficient suction | (5) Increase the speed above the minimum speed of the pump |
|
(6) Oil viscosity too high or too low | (6) Select the working oil with recommended viscosity |
|
(7) Blockage of suction pipe or filter device results in poor oil absorption | (7) Choose the right filter according to the pump and instruction |
|
(8) Poor oil absorption due to high suction pipe or filtration accuracy | (8) Choose the right filter according to the sample and instruction |
|
(9) Air leakage in suction pipe | (9) Check the joints of pipes, seal and fasten them |
|
2. The flow is not enough to reach the rated value | (1) The speed is too low to reach the rated speed | (1) Select the prime mover speed according to the rated speed specified in the product sample or instruction manual |
(2) There is a leak in the system | (2) Check the system and repair the dew point |
|
(3) Because the pump works for a long time and vibrates, the connecting screw of the pump cover is loose | (3) Tighten the screws properly |
|
(4) Same as table 1. (9) | (4) Same as table 1. (9) |
|
(5) Insufficient oil absorption: ① Same as table 1. (9) ② The inlet filter is blocked or the flow rate is too small ③ The suction pipe is blocked or the diameter is small ④介质黏度不当 | （5）吸油不充分的解决办法： ①同本表1.（9） ②清洗过滤器或选用通流量为泵流量2倍以上的过滤器 ③清洗管道，选用不小于泵入口通径的吸入管 ④选用推荐黏度的工作介质 |
|
3.压力升不上去 | （1）泵吸不上油或流量不足 | （1）同本表1. |
（2）液压系统中的溢流阀设定压力太低或出现故障 | （2）重新设定溢流阀压力或修复溢流阀 |
|
（3）同本表2.（2） | （3）同本表2.（2） |
|
（4）同本表2.（3） | （4）同本表2.（3） |
|
（5）同本表1.（9） | （5）同本表1.（9） |
|
（6）同本表2.（5） | （6）同本表2.（5） |
Leave your information and
we will contact you.
we will contact you.
Phone
WhatsApp
WeChat